Installation Guide

Page | 2 Rev A 10/19
1) Uninstall the existing headlights.
a) Remove the trim ring screw at the bottom of the trim ring.
b) Pull the trim ring from the headlight starting at the bottom of the headlight working
around the headlight until the trim ring releases.
c) Remove the headlight retaining screw at the bottom of the headlight, fully remove the
old headlight assembly. BE CAREFUL WHEN REMOVING, DO NOT PULL ON THE WIRES!
d) Unplug the headlight wires from the vehicle wiring harness.
e) Remove the old fender-to-headlight gasket from the edge of the fender’s headlight
bucket.
2) Install the new fender-to-headlight gasket around the headlight bucket.
3) If necessary, install the 9007 to H4 wiring harness adaptor. (some vehicles do not require this)