User manual

87
13. Initial Commissioning
a)Assemblyofthelamentholder
1xlamentholder
1x cylinder head screw M5x20
1xwasherM5(Øoutside15mm)
1x cylinder head screw M5x16
Attachthelamentholdertotheshortaluminiumprolefromthein-
side with the cylinder-head screw M5x20.
Attachthewashertotheoutsideofthelamentholderwiththeother
cylinder-head screw.
Please note! Thegureshowstheconstructionkit.Theshortprole
is covered by the housing in the preassembled device. Install the
lamentholderinthecorrespondingopeningfromtheoutsidehere.
b)PreparingandAssemblingthePrintingPlateSupport
This sub-chapter is only relevant for buyers of the maker construction kits, since the preassembled device does not include a printing
plate support of glass, but an aluminium printing plate that is already installed. Owners of the preassembled device can therefore skip
this chapter.
1xprintingplatesupport(single-panesafetyglass)
2x holding brackets
1xadhesivelm(sizeapprox.likeprintingplatesupport)(notillus-
trated)
Ifyouwanttousetheadhesivelmfromthedelivery,stickitontothe
printing plate support without bubbles.
Degreasetheglasspanelrst.
Cut off protruding edges.
Put the glass panel onto the printing plate and attach it with the two
holding brackets.
If you want to use the width of the entire printing space, do not push
the holding brackets onto the printing plate entirely but only attach
them at the outer-most edge. Otherwise, it is possible that the ex-
truder nozzle catches on them. Caution is required when moving to
theXandYhomepositionsaswellwhentheZ-axisisalreadyinits
home position.
Wipeofftheprintingplaterstifnecessary.