User manual

79
ConnectionofthemotorfortheX-directionandtheY-limitswitch
1x cable 05 approx. 890 mm Thread the cable through between the aluminium prole and the
toothed belt from below and then past the limit switch PCB at the rear.
Connectthe6-pinplugtotheX-motorandthe2pinonetotheY-limit
switch.
Take1adhesivesocket,1cabletie(142mm)and1cabletie(99mm).
Fasten the cable with the adhesive socket and the long cable tie as
illustrated. Use the small cable tie to fasten the cable to the left spacer
of the limit switch.
Degreasetheadhesivearearst.
ThenmovetheY-axisforwardinthedirectionofthedisplay.
Place the cable behind the guide rails and thread it through the cut-
out at the top near the main PCB from the inside.
Connect the 4pin plug to the connection marked in the connection
plan with "MotorX". The pin with the white line must be at the top.
Connect the 2pin plug to the connection marked "limitswitchY" in
the connection plan. The polarity is irrelevant for this.