User manual

7
c)Set-Up,SiteofOperation
• Setupthe3Dprinteronlyonastable,horizontal,sufcientlysizedsurface.
• Choosethesiteofoperationsothatchildrencannotreachtheproduct.
• Whensettingupthe3Dprinter,observethatthemainsplugofthemainsunitmustbeeasytoreachsothatthedevicecanbe
separated from the mains voltage quickly and easily in case of malfunction.
• Thedevicesmustnotbeexposedtoanyextremetemperatures,strongvibrations,highmoisture,suchasrainorsteamorstrong
mechanical strain.
• Neverplacecontainerscontainingliquids,e.g.glasses,vases,etc.onthedeviceorinitsvicinityanddonotpouranyliquidsout
overthedevice.Liquidsmaygetintothehousingandimpairelectricalsafety.Thisalsoposesgreatdangerofreorpotentially
fatal electric shock!
 Ifthisisthecase,rstpowerdowntherespectivemainssocketonallpoles(e.g.switchoffcircuitbreakerandFIswitch)andthen
pull the mains cable of the mains unit from the socket. Disconnect all lines from the device. Do not operate any part of the product
anymore afterwards, but take it to a specialist workshop.
• Neverplaceanysourcesofopenre,suchaslitcandles,onorrightnexttothedevice.
• Whensettingupthemainsunit,makesurethatthemainscableisnotpinchedordamagedbysharpedges.
d) Operation
• Pullthemainscableofthemainsunitfromthesocketatonceifthereisanyelectricalormechanicalproblem!Theprinterwillbe
powered down by this. Only connect the mains unit again when the problem has been removed.
• Neverreachintothe3Dprinterinoperation.Themechanicallymovedpartswithintheprinterposeahighriskofinjury!
• Theprintheadgrowsveryhotinoperation.Nevertouchitduringorjustafteroperation.Letitcooldownsufcientlyrst(approx.
30 minutes).
• Disconnectthedevicefromthemainsbeforemaintenanceworkormodications(unplugthemainsplug!)andletitcooldown.
• Inoperation,therewillbenoiseand,dependingonthelamentmaterialused,smells.Observethiswhenselectingthesiteofsetup
andthelamentmaterial.Ensuresufcientventilationorinstallanextractionsystem.Donotinhalearisingvapours.Whenusing
anyotherthantherecommendedlamentmaterial,poisonousvapoursorgasesmaydevelop.
• Ifthemainslineofthemainsunitorthemainsunititselfisdamaged,donottouchit.Firstpowerdowntherespectivemainssocket
onallpoles(e.g.switchoffcircuitbreakerandFIswitch)andthenpullthemainscablefromthesocket.Neveroperatetheproduct/
mains unit with a damaged mains line.
• Nevertouchthemainslineorthemainsplugofthemainsunitwithwetordamphands.Thereisariskofpotentiallyfatalelectric
shock!
• Neveroperatethedeviceunattended.
• Onlyoperatethedeviceinmoderateclimates,neverintropicalclimates.