User manual

Assemblyofthecoolingbodiesonthemotordrivers

4x motor driver

4x heat sink

Removetheprotectivelmfromthebottomofthecoolingelement

and stick it centred onto the chip of the motor driver.

Attention! Do not stick the cooling body too close to the soldering

points of the pin strip! Danger of short-circuit!

Repeat this with the other 3 motor drivers.

The 5th enclosed motor driver is not needed. It is a reserve.

Assemblyofthemotordrivers

1x PCB holder with main PCB

4x motor driver

Push the motor driver onto the additional PCB as illustrated.

The potentiometers on the motor drivers always must point away from

the green connection plug.

3 motor drivers must be pushed onto the right side. The pin strips

presentalsotpreciselyhere.

Only 1 motor driver needs to be pushed onto the left side. It must be

inserted at the very bottom of the pin strip.