User manual

64
Align the display when all screws are inserted. Particularly observe
that the dial switch does not hit the display holder. Tighten all nuts
(hexkey5mm).
Youmayneedtoalignthedisplaymorepreciselyaftercommission-
ing.
Applythelmtothedisplayagaintoprotectit.
Installationoftheoperatingbutton
1x display holder
1x operating button
Push the operating button onto the shaft of the dial switch and attach
it by tightening the slotted screw.
The button must be aligned so that it still has enough distance from
the display holder to allow clean pushing of the button. The screw
must meet the slot in the dial switch.
Push the operating button to test it.