User manual

Preparationofthedisplay

1x display

4xspacer3mm(diameterinside3mm)

Push one spacer between the display and control PCB in each at-

tachment hole.

Align the spacer precisely with the holes.

Installationofthedisplayinthedisplayholder

1x display holder

1x display

4x cylinder head screw M2.5x20 black

4xspacer9mm(diameterinside3mm)

4x nut M2.5 black

Removethelmfromthedisplayrst.

Attach the display to the display holder from the inside. The dial switch

must be guided through the corresponding opening.

Start at the outside.

Install the screws one at a time. After inserting a screw, secure it with

a nut.

The sequence from the outside is:

Cylinder-head screw - display holder - spacer 9 mm - display

(withspacer3mm)-nut