User manual

TurnthenozzlestockintothePEEKpartcarefully.Itwillonlytinone

side because the opening is larger on the other side.

Tighten the nozzle stock hand-tight with a 13 mm spanner.

Push the PTFE insert into the PEEK part. Take a hexagon socket

wrench with at least 3 mm and push the PTFE insert entirely into the

PEEK part.

Carefully turn the extruder inlet into the PEEK part and tighten it man-

ually as far as possible.

Screw the M6-nut onto the thread of the nozzle stock to the stop.

Please observe that the nut in the delivery is a little lower than in the

gure.