User manual

Attachtheangenuttothetable.

2x cylinder head screw M4x16 black Liftthetableandturntheangenutalmostallthewayup.Putthe

table back down on it.

Turn the two cylinder-head screws into the thread bores of the table

throughtheboresoftheangenutfrombelow.

Tighten the screws.

Optionally, the screws can be secured with threadlocker varnish.

Lower the table again by turning the spindle.

Ifyoundwhenturningthetableupordownsubsequentlythatitmovesstifyatthetoporbottom,releasetheattachmentscrews

ofthetwoguiderailsinsequence.Tightenthescrewagainbeforereleasingthenextone.Youmayneedtoreleasetheundertable

or the tappets again as well.

AssemblyoftheZ-limitswitch

1x limit switch holder plate

1x limit switch PCB

2x cylinder head screw M2x8 black

2x nut M2 black

Mount the limit switch PCB on the limit switch holder plate as illus-

trated with the two M2-cylinder-head screws and M2 nuts. The cut-out

and the limit switch must be aligned as illustrated. The two nuts must

be installed on the side of the limit switch.