User manual

Tighteningofthetabletotheguiderails

Liftthetableandturntheangenutallthewaydown.Thenputthe

table onto the nut.

Movethetableupanddowntwiceandthentothemiddle(rightg-

ure). For the table to stay in place on its own, push a cylinder-head

screw M3x10 or longer into a hole in one of the two guide rails from

behind and carefully place the table down on it.

Measure the distance between the right guide rail and the right alu-

miniumproleatthebottom(1)andtop(2)each.

Align the guide rail at the bottom and top until the distance at 1 and

2 is the same. Check that the rails are straight with a stop angle ad-

ditionally.Then carefully tighten rst the lower screw andthen the

upper screw of the right guide rail slightly. Check the distance at 1

and 2 again.

Move the table up and down twice again; then let it return to the cen-

tre.

Repeat the procedure on the left.

The table should still move freely.

Check that the guide rails are straight with a stop angle

several times while tightening them!

 Placethestopangleontopoftheupperaluminiumprole.

Lowerthetableagainandputitdownontheangenut.

Alignthetablestraightwiththeholesovertheguidecarriage(upper

arrows) and then tighten the cylinder-head screws at the left and right

tabletappetscarefullyalternatingly,rstslightlyandthentightly(lower

arrows).