User manual

51
Assemblyofthespindle
1xspindlewithinstalledangenut
1x clutch
Greasethespindlewithall-purposegreaseafterinstallationand
later on demand.
Place the coupling on the spindle on the side that has no thread.
Tightenthetwoleftthreadedpins(arrowsinthegure)ofthecou-
pling.
Simply leave the second screw loose in the coupling.
Optionally, the screws can be secured with threadlocker varnish.
Installationofthespindle
Theangenutonthespindleshouldberoughlycentred.
Move the table up and thread the spindle through the table bore from
below.
Turn the spindle until one of the two lower threaded pins of the cou-
plingispreciselyalignedwiththeattenedsideofthemotorshaft.
Pushthecouplingontothemotorshaft and rstslightlytightenthe
threadedpinthatyouhavepreviouslyalignedwiththeattenedside.
Then tighten the other lower threaded pin slightly as well. Finally tight-
en both pins.
Important! The coupling level must be adjusted so that it has a dis-
tance of about 0.5 to 1 mm from the motor holding plate.
Also particularly observe that the spindle and the motor
shaft in the coupling must not meet. They should be at a
distance of approx. 3 mm. Otherwise, the coupling will no
longer be functional.
When you have tightened the screw, turn the spindle and check if the
coupling moves smoothly and that it does not hit the motor holding
plate.
Optionally, the threaded rods can be secured with threadlocker var-
nish.