User manual

Installationoftheguidecarriageplateontherightofthebasicframe

1x right guide carriage plate with motor and limit switch

4x countersunk head screw M3x10 black

Install the right guide carriage plate with the 4 recessed-head screws

ontheguidecarriageoftherightY-guiderail.

Optionally, the screws can be secured with threadlocker varnish.

Check after installing the 2nd guide carriage plate whether both guide carriage plates are straight and parallel with the front alumin-

iumproleinstalledcrosswise.Ifthisisnotthecase,releasetheattachmentscrewsoftherespectivealuminiumproletowhichthe

guide rail with the guide carriage plate that is not straight is installed. Align the respective guide carriage plate and tighten the screws

again.

InstallationoftheguiderailfortheX-direction

1xguiderailwithguidecarriage(355mm)

3x cylinder head screw M3x8

1x aluminium block silver

1x cylinder head screw M3x20

Remove the two cable ties from the guide rail.

Releasethe4attachmentscrewsinbothY-guiderailssothatthey

can be moved a little.

Insert the guide rail in the groove of the left and right guide carriage

plateseach(1).

Loosely attach the guide rail on the left side of the outer bore with an

M3x8cylinder-headscrew(2).

Use two M3x8 cylinder-head screws in the two outer-most bores for

attachment on the right. Tighten the two screws only loosely as well

(3).

On the left side, attach the silver aluminium block with the cylinder-

headscrewM3x20(4)inthesecondbore.

Now tighten all 4 screws in sequence.