User manual

29
Attachmentoftheinfeedknurltothelamentinfeedmotor
1x actuator
1x feed knurl 5 mm
2x threaded pin M3x5
Push the feed knurl onto axe of the actuator and attach it with 2
threadedpinseach.Athreadedpinmustmeettheattenedsideof
the axis.
The feed knurl must be as close as possible to the motor. As refer-
ence for the distance, push a feeler gauge sheet with 0.1 or 0.2 mm
between the knurl and the motor.
Optionally, the threaded rods can be secured with threadlocker var-
nish.
Assemblyoftheballbearingholders
1x ball bearing holder
1xballbearingFZ0463u-shaped(diameterinside/outside(4/13mm)
1x cylinder pin 4x14 mm
Placetheballbearingholderonalevelandrmbase.Placetheball
bearing into the holder cut-out and carefully drive the cylindrical pin
through the holder into the ball bearing with a hammer.
Finally, use a mounting mandrel or punch to lower the pin slightly into
the hole.
The ball bearing has a little play on the left and right. The pin can be
moved in the ball bearing holder. The ball bearing must not protrude
from the holder when you move the ball bearing back and forth.