User manual

InstallingtheY-motorholdertothebasicframeandtensioningthetoothedbelt

1xY-motorholderwithinstalledmotor

4x cylinder head screw M5x8 black

2x slot nut M5

Pushthe 2slot nuts intothe right aluminiumprole at therear as

showningure(wherethedoublesprocketisinstalled).

The threads each must point outwards.

AlignthetwoslotnutswiththeboresoftheY-motorholder.

Attachthesprocketofthemotorasshownintheguretotheshort

toothedbeltofthedeectionshaft.

AttachtheY-motorholdertothetwoslotnutslooselywiththetwoM5

cylinder-head screws.

Totensionthetoothedbelt,pushtheY-motorholderwiththemotor

up until the toothed belt is tensioned so that it can still be twisted by

180°withtwongers.

Last, tighten the two screws.