User manual

Assemblyoftherightsidepart(frontview)

1xaluminiumprole284mmwithoutbore

1xaluminiumprole284mmwithboreatthecentre

1xaluminiumprole356mmwith4boresand1cut-outfortheballbearing

1xaluminiumprole356mmwith4bores

4x cylinder head screw M5x20

Thetwoshortprolesarethesameonbothsides.

Inthelongprolewiththecut-outfortheballbearing,thecutsideof

the bore, at the height of the cut-out for the ball bearing, must be on

theright(leftredbox).

Inthesecondlongprole,themilledpartoftheupperbore,totheright

of the milled side of the bore, must be below.

Assemblethe4aluminiumprolesasillustrated.Screwonecylinder

headscrewintoeachofthe4bores(2),butdonottightenthescrews

yet. All parts must remain movable.

Thisgureshowstherightsidepartfromtheinside.Thecut-outfor

theballbearingmustbeattheupperleft(1).

Themilledsidesoftheboremustpointtotheoutsideeach(2).The

screws also need to be inserted into the respective bore from the

milledsidebore(2).

Themilledsideoftheboreinthelowercross-prolemustpointdown

(3).

Thisgureshowstherightsidepartfromtheoutside.

Asthegureshows,themilledsidesofthe4boresoftheouterpro-

lesmustpointup(seethe4arrows).