User manual

147
c)RecommendedTighteningTorqueoftheScrews
Description Threadsize Torque
Screw together the frame M5 3 Nm
Attach the guide rail to the frame M3 2 Nm
Attach the motor to the motor plate M3 1.7 Nm
Attach the plate to the frame M5 3 Nm
Attach the sprocket to the stepper motor M3 0.7 Nm
MotorattheY-motorholder M3 1.7 Nm
Y-motorholderattheframe M5 3 Nm
Infeed knurl on the motor shaft M3 1.7 Nm
Screw quick closure to the adapter M5 3 Nm
Attach the adapter with the nut. M8 5 Nm
Motor at the extruder motor holder M3 1.7 Nm
Ballbearingholderatthelamentinfeedmotor M3 1.7 Nm
Screw the screw to the spring holder M4 3 Nm
Attach the infeed unit to the frame M5 3 Nm
Screw the left guide carriage plate to the guide carriage M3 1.5 Nm
Attach the sprocket to the stepper motor M3 0.7 Nm
Screw the actuator to the right guide carriage plate M3 1.7 Nm
Screw the end stop to the right guide carriage plate M2 0.3 Nm
Screw the right guide carriage plate to the guide carriage M3 1.5 Nm
Screw the guide rail and the aluminium block to the guide carriage plate on the left and right M3 1.7 Nm
Screw the black aluminium block to the frame M3 2 Nm
Screw the black block, black disc, to the guide carriage plate on the left and right M4 3 Nm
Tighten the screws of the sprockets M3 0.7 Nm
Screw the extruder holder to the belt tappet M3 1.7 Nm
Screw the quick closure to the extruder holder M5 3 Nm
Screw the end stop to the extruder holder M2 0.3 Nm
Screw the fan to the fan sheet M2 0.3 Nm
Screw the fan sheet to the extruder holder M3 1.7 Nm
Screw the extruder holder to the guide carriage M3 1.7 Nm
Screw the belt tensioner to the left guide carriage plate M4 3 Nm
Screw the undertable to the table tappet M4 4 Nm
Screw the undertable to the guide carriage M3 1.9 Nm
Clamp the coupling to the spindle M3 1.7 Nm
Clamp the coupling to the motor shaft Z M3 1.7 Nm
Tighten the frame again M5 3 Nm
Attach the guide rail to the frame M3 1.7 Nm
Screwtheangenuttotheundertable M4 4 Nm
Screw the limit switch holding plate to the limit switch M2 0.3 Nm
Screw the limit switch holding plate to the frame M5 3 Nm