User manual

140
23.Handling
• Neverconnectthemainsplugtoamainssocketimmediatelyafterthedevicehasbeentakenfromacoldtoawarmenvironment.Theresult-
ing condensation may destroy the device. Allow the device to reach room temperature before connecting it. Wait until the condensation has
evaporated.
• Neverpullthemainsplugfromthemainssocketbythecable.Onlypullitfromthemainssocketbytheintendedgripareas.
• Disconnectthe3Dprinterfromthemainsvoltageifyouarenotgoingtouseitforanextendedperiodoftime.
• Disconnectthemainsplugfromthemainssocketduringthunderstormsforreasonsofsafety.
• Theextrudercanheatupstronglyinoperation.Donottouchthisduringorjustafteroperation.Letitcooloffagain.
24. Disposal
Electronic devices are recyclable and should not be disposed of in household waste!
Dispose of the product according to the relevant statutory regulations at the end of its service life.
25.TechnicalData
a) Printer
Itemno./Device 1515049/constructionkit 1534908/preassembleddevice
Operating voltage 12 V/DC
Power input max. 5 A max. 16 A
Total power intake max. 60 W max. 200 W
Power of the heating plate X 120 W
Production process FFF(FusedFilamentFabrication)/FDM(FusedDepositionModelling)
Printingspace(WxDxH) approx.210x135x170mm(X,Y,Z)
Printing layer thickness 0.05 - 0.3 mm
Nozzle diameter 0.4 mm
Suitablelamentmaterial PLA PLA, ABS, Bendlay, HIPS, NinjaFlex, Nylon,
PET, Polyamide, PP, PS, PVA
Filament-diameter 1.75 mm
Extruder temperature 120-270°C
Heating plate temperature. X max.130°C
Interfaces USB 2.0 and SD/SDHC card reader
Dimensions(WxHxD) 400 x 500 x 600 mm
Weight 8 kg 11 kg
b) Mains Unit
Itemno./Device 1515049/constructionkit 1534908/preassembleddevice
Operating voltage 110 - 240 V/AC, 50 - 60 Hz 110 - 240 V/AC, 50/60 Hz
Output 12 V/DC, 5 A 12 V/DC, 16 A