User manual

123

(1) Loopsarecircles,thataredrawnaroundtheobjectwhenprintingstarts,stabilisethelamentowbeforetheactualobjectisprinted.Here,

number,distancefromtheobject,heightandminimumlengtharespecied.

(2) "Brim" is a thin edge that is placed right around the object to increase the footprint and thus adhesion to the printing plate. Here, the width

ofthebrimisspecied.

(1) Selectionandadjustmentofthesupportingmaterialthatisneededwhenprintingcomplexobjectssuchasbridgesorhollowspaces(poss.

requiredforprintingobjectwithoverhangs>45°).

Therstprintingattemptsshouldbewithoutasupportingbrimsincetheresulthereisusuallybetteragain.