User manual

114

d)ManualOperationviatheSoftware

Click the tab "Manual Control"(1)onthemainscreenofthesoftware.

Beforetryingoutmanualprintercontrol,thesettingsforthelimitswitchesfortheZandYaxesmusthavebeenperformed.

Inthepreassembleddevice,thebasicsettingshavealreadybeenperformedatproductionbutshouldbeinspectedagain

for reasons of safety.

 Ifthisisnotobserved,theremaybedamagetothe3Dprinter(lossofwarranty/guarantee).

(2) Allaxesmoveintothehomeposition

(3) X-axismovesintothehomeposition

(4) Y-axismovesintothehomeposition

(5) Z-axismovesintothehomeposition

(6) Thearrowiconscanbeusedtooperatethecorrespondingaxesmanually.Dependingonwherethearrowisclicked,differentlylongroutes

are run. The route length is displayed when the mouse pointer is moved across the corresponding button of the arrow.

(7) Selectingtheextruder(optional)

(8) Filamentfeedforthechosenextruder(extrudermustbeheatedup!)

(9) Settingoftheprintingspeed

(10)Switchingthefanon/off;Totherightofthis,thespeedcanbeset

(11)Switchingtheheatingbed(inthepreassembleddeviceorwhenusingtheoptionallyavailableheatingplatekit)on/off;thetemperaturecan

be set on the right

(12)Switchingtheextruderheaterforthe1stextruder(inthermwareextruder0)on/off;Totherightofthis,thetemperaturecanbeset