User manual

112

c)ConnectionoftheConnectedPrinter

Start the programme Repetier-Host and click on "Printer Settings" at the upper right in the window.

(1) Selecttheprinter"RF500_3D" in the menu above.

(2) Settheportandcheckthebaudrate.Ifyouhaveselectedtherightprinterin(1),thebaudrate(2)isalreadycorrectlypre-setto"115200".

Theportnumber(2)issystem-dependent.

Usually, the setting "Auto" should work

withthecurrentversionofthesoftware(as

of 1.6.2).

If this does not work properly for you, you

can check the port in the device manager

of the control panel, under connections

(COMandLPT).

Then set the COM-port from the device

manager in the software.

(3) Click"OK"(3).