User manual
• Repeat STEP 4 for second and third
points (calibration sequence and
movement path of nozzle are shown).
5
Filament setup
2
• Install lament tube into the lament
tube holder.
• Put the lament on the lament spool
holder.
1
• Feed lament through lament tube
until approx. 5 cm are visible on the
extruder end.
3
Filament loading
2
• Select < Move 1mm >.• In < Prepare > menu, select rst
< Auto Home >, then < Move axis >.
1
4
• Turn knob anticlockwise (+20) to lower
the build bed.
• Select < Move Z >.
3
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microlming, or the capture in
electronic data processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited.
This publication represents the technical status at the time of printing.
Copyright 2017 by Conrad Electronic SE. *1507428_V2_0217_02_LS_m_qsg_GB
6
• Select < Preheat PLA > under the
< Prepare > menu. Nozzle will be
preheated to default temperature 220 °C.
• For protection, nozzle will be cooled
down back, if no action is taken after 5
minutes.
• Insert the lament into the hole of the
extruder.
5
8
• Gently push and guide the lament
into extruder until it exits from the
nozzle.
• Feel the lament slowly getting drawn
into the extruder.
• When the current temperature has
reached the target temperature (at
least 170 °C), select < Load lament >.
7
If no lament exits from the nozzle after lament movement stopped, select
< Load lament > again. After lament is loaded, lament residue can be removed
with the tweezers.
Start to print
2
• Navigate in the menu and select
< 3D Model >. Select a printable
model for example < RF100.gcode >.
• Press the control knob and select
< Print from SD > in < Main > menu.
1
• DONE.
3
Product features
• Max. printed object size: 100 x 100 x 100 mm
• Print various materials as PLA, Wood, Elastic, Copper
• Layer resolution 0.1mm - 0.2mm
• Nozzle size 0.4mm
• Support printing from SD card & PC
• “Cura“ software included
• Single extruder
• Print speed 30mm/s - 300mm/s
• LCD screen with control knob