Manual

14
11. Setting up
11.1. Placing the printer
Place the printer in a location that satisfies the following requirements:
◼ The surface is flat and steady.
◼ The surface is insensitive to rubber. The rubber feet can leave marks.
◼ The inclination angle with respect to the paper feed slot will not exceed ±10° after placement.
◼ No sources of water are or will be nearby.
◼ The location is and will be free from vibrations and shocks.
11.2. Connecting the host computer
Connect the printer to the host computer via one of the communication interfaces: USB, R232,
Ethernet.
Note: if you have doubts about which connection is suitable, reach a professional for help.
1. Move the power switch to position 0 to power off the printer.
2. Connect the printer to the host computer via the selected communication interface.
11.3. Connecting the cash drawer
Important: Only connect the cash drawer interface on the printer to a 24 V/DC cash drawer
device.
1. Move the power switch to position 0 to power off the printer.
2. Connect the cash drawer to the cash drawer interface on the printer.
11.4. Connecting to power
Connecting:
1. Move the power switch to position 0 to power off the printer.
NOTICE: the plug on the power adaptor cable only fits one way. Do not force it into the socket.
2. Connect the power adaptor cable to the power input socket at the rear of the printer.
> The plug locks in the socket.
3. Connect the mains cable and the power adaptor.
4. Connect the power adaptor to a suitable mains socket.
Disconnecting:
1. Move the power switch to position 0 to power off the printer.
NOTICE: the plug is locked in the socket. Unlock the socket before removing to prevent damage.
2. Hold the plug and pull it to release the lock. Remove the plug.