User manual

4
I-5. WPS Setup
If your wireless router/access point supports WPS (Wi-Fi Protected Setup) then you can
use this method to setup your wireless extender.
1. Press the WPS button on your wireless
router/access point to activate its WPS.
Please check the instructions for
your wireless router/access point for
how long you need to hold down its
WPS button.
2. Within two minutes, press and hold the WPS
button on the wireless extender for two seconds.
The extender’s green WPS LED should flash to
indicate that WPS is in progress.
3. The devices will establish a connection. The extender’s green WPS LED should display
on for 30 seconds to indicate a successful connection.
I-6. WPS Button with Wireless Scheduling
When a wireless schedule is in operation so that 2.4GHz is active and 5GHz is off, the WPS
button’s primary function is to activate the 5GHz network.
Press the WPS button once to activate/wake the 5GHz network.
Following this, the WPS button functions normally as described above in WPS Setup.