User manual

57
IV. Appendix
IV-1. Configuring your IP address
For first time access to the URL http://renkforce.setup please ensure your computer is set
to use a dynamic IP address. This means your computer can obtain an IP address
automatically from a DHCP server. You can check if your computer is set to use a dynamic
IP address by following VII-1-1. How to check that your computer uses a dynamic IP
address.
Static IP users can also temporarily modify your computer’s IP address to be in the same
IP address subnet e.g. 192.168.9.x (x = 3 – 254) as the EW-7476RPC in order to access
http://renkforce.setup .
The EW-7476RPC’s default IP address is 192.168.9.2.
The procedure for modifying your IP address varies across different operating systems;
please follow the guide appropriate for your operating system in IIV-1-2. How to modify
the IP address of your computer.
Static IP users please make a note of your static IP before you
change it.
You can assign a new IP address to the device which is within the subnet of your network
during setup or using the browser based configuration interface, so that you can access
the URL http://renkforce.setup in future without modifying your IP address.
Please remember to change your IP address back to its
original value after the device is properly configured.