User manual

DTIM Period

Set the DTIM period of wireless radio. The default

value is 3.

Data Rate

Set the wireless data transfer rate. The default is set

to Auto.

N Data Rate

Set the data rate of 802.11n. The default is set to

Auto.

Channel Width

Select wireless channel width (bandwidth used by

wireless signals from the device) – the

recommended value is Auto 20/40MHz.

Preamble Type

Set the wireless radio preamble type. The default

value is “Short Preamble”.

CTS Protect

Enabling this setting will reduce the chance of radio

signal collisions between 802.11b and 802.11g

wireless access points. It’s recommended to set this

option to “Auto”.

Tx Power

Set the power output of the wireless radio. You may

not require 100% output power. Setting a lower

power output can enhance security since potentially

malicious/unknown users in distant areas will not

be able to access your signal.

Tx power works in conjunction with the switch on the side

of the device. The switch is the primary setting and the Tx

power value here will be a percentage of the slide switch

setting. E.G If the slide switch is set to Green Mode (25%)

and Tx power to 75%, the overall output will be 75% of

25%.