Instructions

33
Menu overview:
Display Setting Function
Addr A001-A512 DMX starting address
CHnd 4CH / 6CH / 8CH Number of DMX channels
SLAU NO / YES Slave mode no/yes
SOUn Sd-1 / Sd-2 / Sd-3 Sound-to-Light mode 1 / 2 / 3 (3 different effects)
SP-1 to SP-8 Sound-to-Light (microphone sensitivity low > high)
JUNP JU01-JU20 Colour change operation (change speed slow > fast)
FL-0 to FL-4 Colour change operation (strobe speed slow > fast)
FAdE Fd01 to Fd15 Fade operation(colour change slow > fast)
AUtO Automatic mode with changing effects
COLO CL00 to CL11 Static colours (12 colour settings)
FL00 to FL15 Static colours (strobe speed slow > fast)
NAnU r000-r255 Manual colour setting brightness red off > full brightness
G000-G255 Manual colour setting brightness green off > full brightness
b000-b255 Manual colour setting brightness blue off > full brightness
U000-U255 Manual colour setting brightness white off > full brightness
bLnd NO / YES Blackout Mode no/yes
dISP NO / YES Display alignment turned 0°/180°
b) Use with an external DMX Controller
Each DMX device in a DMX chain requires a so-called DMX starting address to be clearly identified by the
controller. This DMX starting address specifies the first DMX channel to which the effect light responds.
The remaining control channels come after this first DMX channel (DMX starting address).
The effect light requires 4, 6 or 8 free DMX channels depending on operating mode.
Setting the DMX starting address
• Push the button MENU until “Addr” is displayed and push the button ENTER.
• Select the desired start address A001-A512 with the UP and DOWN buttons.
• Press the ENTER button to confirm your selection.