Instructions

26
Pin assignment of the DMX connection: Pin1 = earth / Pin2 = (-) / Pin3 = (+).
Never connect the earth pin GND to the casing earth of the eect light; this may result in interfer-
ence in signal transmission caused by ground loops.
b) Setting up a Master-Slave Chain
The eect light can be operated controlled by a DMX controller or in a master-slave chain. In that case, the
integrated controller of the master device controls the connected slave devices.
• ConnecttheDMXOUT(5)portofthemasterdevicetotheDMXIN(4)portoftherstslavedevice.
• ConnecttheDMXOUT(5)portoftherstslavedevicetotheDMXIN(4)portofthesubsequentslave
device.
• Proceedasdescribedabovewithallremainingslavedevices.
• PluganXLRplugwithaterminatingresistorintotheDMXOUT(5)portofthelastslavedevice(asde-
scribed in section "Connection of a DMX Controller").
10. Mains Connection
The mains socket to which the eect light is connected must be close to the device and easily
accessible to quickly separate the device from the mains voltage in case of an error.
Ensure that the voltage indication on the eect light matches the mains voltage of your power
supply. Never try to operate the device with any other voltage.
Do not let the mains cable come into contact with other cables.
Be careful when handling mains cables and mains connections. Mains voltage may cause po-
tentially fatal electric shock.
Make sure that no cables are lying around openly. Install cables professionally to prevent ac-
cidents.
• Plugthemainsplugofthemainslineintoagroundedsocket.
• Oncethedeviceisconnectedtothenetwork,thedisplay(1)willlightupandthedevicewillstartopera-
tion.