Instructions

25
• Ifyouwanttosetuptheeectlight,turnthetwomountingbracketssothattheyformabaseandthen
tighten the thumbscrew.
• Ifyouwanttosuspendtheeectlight,turnthemountingbracketsup.
• Installtheeectbeamerontheceiling,thewallorasuitablecrossbeamwiththemountingbracket.The
assembly must never swing freely.
• Securethedevicewithassemblyequipmentthatiscompatiblewiththeattachmentsurfaceandsuitable
for carrying the weight of the eect light.
• Additionallysecuretheinstallationwithasuitablesafetyrestraintcableorasafetynet.Thesafetyreten-
tion rope or the net must be designed to support the eect light in the event of failure of the main support
system independently of the main attachment.
• Setthedesiredinclinationangleandtightenthethumbscrewwell.
9. DMX Connection
You can operate a maximum of 32 devices in a DMX chain without overloading the controller.
The maximum total length of the DMX chain should not exceed 300 m.
Use of XLR microphone cables may cause interferences in the DMX signal transmission. In this
case, please use special DMX high-frequency cables.
a) Connection of a DMX Controller
Only connect the device to a DMX controller with a DMX-512 protocol.
• ConnecttheportDMXIN(4)withtheoutputoftheDMXcontroller.
• Thecontrollermusthave4,6or8freecontrolchannels(dependingonDMXoperatingmodesetatthe
eect light).
• ConnectDMXOUT(5)withtheDMXinputofthesubsequentdevice.
• ProceedaccordinglywithallotherdevicesoftheDMXchain.
• IftheeectlightisthelastortheonlydeviceintheDMXchain,insertanXLRplugwitha120ohm/0.25W
terminating resistor into the DMX OUT (5) socket (between Pin2 and Pin3).