User manual

42
i) Manual Operation
• In the menu, select Manual Control and push the ENTER (11) button.
• Select the desired menu times with the UP (10) or DOWN (13) buttons and push the ENTER (11) button.
• Set the desired DMX values with the UP (10) or DOWN (13) buttons and push the ENTER (11) button to save.
- Pan = swivel position
- Tilt = tilt position
- XY Speed = movement speed
- Dimmer = total brightness
- Strobe = strobe speed
- Red = brightness red
- Green = brightness green
- Blue = brightness blue
- White = brightness white
12. Handling
• Never connect the mains plug to a mains socket immediately after the device has been taken from a cold to a warm
environment. The resulting condensation may destroy the device. Allow the device to reach room temperature
before connecting it. Wait until the condensation has evaporated.
• Never pull the mains plug from the mains socket by the cable. Only pull it from the mains socket by the intended
grip areas.
• Unplug the mains plug from the mains socket if you are not using the device for an extended period of time.
• Disconnect the mains plug from the mains socket during thunderstorms for reasons of safety.
• Neverputanylterfoils,masksorothermaterialsoverthelightexit.Thismaycauseheatdamageanddangerof
re.
• The device may heat up during operation. Never touch the casing during operation. Let the effect light cool off after
operation before touching or cleaning the casing.
• Donotcoverthedevicetoensuresufcientventilation.Aircirculationandthemovementoftheprojectorhead
must not be impaired by objects such as magazines, tablecloths, curtains, etc. During operation, keep a minimum
distance of 0.5 m around the device.
• The device is not suitable for continuous operation. Consistent compliance with operating breaks (every 8-12 hours)
extends service life. Let the device cool off for some time before starting it up again (approx. 2 hours).