User manual

DMX Operation

• Push the FUNCTION (11) button 5x as described above and set the DMX start address.

TheDMXstartaddresscanbesetfrom1to510anddenestherstchanneltowhichthedevicereacts.

• You can now control the device from your DMX controller. For the functions of the individual channels, see the

following table.

DMX channel Value Function

1 0-255 Fog amount 0-100 %

2 0-255 No function in fog operation

3 0-127 Fog operation off

128-255 Fog operation on

Ensurethatthetankneverrunsemptyduringfogoperation.Observethellleveldisplay(7)forthis.

If this happens anyway, the message BEWARE: NO LIQUID will appear in the display (10). Switch off the

device without delay using the POWER (8) switch in this case and let it cool off.

 Rellthetankaftercooling.

If no fog or haze emerges, the device is still warming up or reheating.

Slight fog lag after deactivation of the device is normal and does not suggest a defect.

If you no longer require the device, disconnect the mains plug and let the device cool down.

Then empty the tank if the device is not used for any extended period. This prevents leaking of fog liquid

during transport or storage.