User manual

Example 3:
You have programmed 3 telephone numbers.
The call sequence is set to 2.
Message repetitions is set to 2
The call confirmation code is set to 1 (factory setting).
In an alarm situation the sequence with confirmation is as follows:
Telephone number Text message
1st number 1st repetition - signal tone
2nd repetition - signal tone
Telephone dialler hangs up.
2nd number 1st repetition - signal tone
2nd repetition - signal tone
Confirmation with button 1.
You can now listen to the room
for a predefined period of time
and then the telephone dialler
hangs up.
If the code for call confirmation is set to 1 and the person called presses button 1 on his/her telephone
(which must be set to dual tone multifrequency) after the text message has been transmitted, then the
call recipient can listen to the room where the external microphone or the alarm control centre is located
for a predefined period of time After this period of time, the telephone dialler immediately ends the call
sequence and no more calls are made.
Memory location Code Confirmation
73 0 or 1 #
Code = This is where you set the call confirmation.
0 = Signal transmission activated
1 = Voice message is activated
The factory setting for the code is 0.
123