User manual

10.13.3 Programming signal sequence
You can set the alarm control centre to emit a unique signal sound series after the call is made.
In this case it does not matter whether the signal transmission is activated or not. After the call
the entered series of sounds will be repeated once before the telephone dialler ends the call.
Example:
63 > 0 > 0987654321 > PAUSE > 5 > PAUSE > 1234 > #
Explanation:
63 Memory location for telephone number
0 Code selection for the series of digits
0987654321 Telephone number
PAUSE End of the pause entry
5 Entered pause time (pause can vary from 1 to 99 seconds)
PAUSE End of the pause entry
1234 Digit combination 1234 should be emitted (DTMF button tones)
# Ende der Programmierung
10.14 Setting the call sequence
This chapter allows you to set the dialling sequence. You determine how often the telephone dialler dials
the individual telephone numbers.
Memory location Code Confirmation
71 1 to 8 #
The factory setting for the sequence is 4.
If you have saved several telephone numbers, the telephone dialler pauses for approx. 5 seconds between
the numbers. If a new sequence begins (from the start) then the pause is 60 seconds.
10.15 Setting number of repetitions
This is where you set the number of times the voice message / signal sounds should be repeated.
Memory location Code Confirmation
72 1 to 8 #
The factory setting for the repetitions is 4.
120