User manual
Operating instructions
Music desk LED light
Item no. 1377591
Intended use
The LEDs in the music desk light emit a white light.
The neck can be bent to adjust the height and the
direction of the light. The light can be controlled
using a touch strip.
It is intended for indoor use only. Do not use it
outdoors. Contact with moisture, e.g. in bathrooms,
must be avoided under all circumstances.
For safety and approval purposes (CE), you must
not rebuild and/or modify this product. If you
use the product for purposes other than those
described above, the product may be damaged. In
addition, improper use can cause hazards such as
short circuiting, re, electric shock etc. Read the
instructions carefully and keep them. Make this
product available to third parties only together with
its operating instructions.
This product complies with the statutory national
and European requirements. All company names
and product names are trademarks of their
respective owners. All rights reserved.
Delivery content
• Music desk light
• 3 x AAA batteries
• USB cable (approx. 1.45 m)
• Operating instructions
Safety instructions
Read the operating instructions carefully
and especially observe the safety
information. If you do not follow the safety
instructions and information on proper handling in
this manual, we assume no liability for any
resulting personal injury or damage to property.
Such cases will invalidate the warranty/guarantee.
• The device is not a toy. Keep it out of the reach of
children and pets.
• Do not leave packaging material lying around
carelessly. This may become dangerous playing
material for children.
• Protect the product from extreme temperatures,
direct sunlight, strong jolts, high humidity,
moisture, ammable gases, vapours and
solvents.
• Do not place the product under any mechanical
stress.
• If it is no longer possible to operate the product
safely, take it out of operation and protect it from
any accidental use. Safe operation can no longer
be guaranteed if the product:
- is visibly damaged,
- is no longer working properly,
- has been stored for extended periods in poor
ambient conditions or
- has been subjected to any serious transport-
related stresses.
• Please handle the product carefully. Jolts,
impacts or a fall even from a low height can
damage the product.
• Correct polarity must be observed while inserting
the batteries.
• Batteries should be removed from the device if
it is not used for a long period of time to avoid
damage through leaking. Leaking or damaged
batteries might cause acid burns when in
contact with skin, therefore use suitable
protective gloves to handle corrupted batteries.
• Batteries must be kept out of reach of children.
Do not leave batteries lying around, as there is
a risk that children or pets may swallow them.
• All batteries should be replaced at the same
time. Mixing old and new batteries in the device
can lead to battery leakage and device damage.
• Batteries must not be dismantled,
short-circuited or thrown into re. Never
recharge non-rechargeable batteries. There is a
risk of explosion!
• Lay cables such that they do not present a
tripping hazard.
• Fire hazard! Never cover the product during use.
• Also observe the safety and operating
instructions of any other devices which are
connected to the product.
• Attention, LED light:
- Do not look directly into the LED light!
- Do not look into the beam directly or with
optical instruments!
• Consult an expert when in doubt about operation,
safety or connection of the device.
• Maintenance, modications and repairs are to
be performed exclusively by an expert or at a
qualied shop.
• If you have questions which remain unanswered
by these operating instructions, contact our
technical support service or other technical
personnel.