Instructions
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microlming, or the capture in
electronic data processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited.
This publication represents the technical status at the time of printing.
Copyright 2017 by Conrad Electronic SE. *1522157_V2_0117_02_LS_m_gb
9
10
• Take note of extruder position.
• Remove extruder from the extruder
carriage.
• Align replacement extruder with holes in
the extruder carriage.
• Bolt extruder down with screw removed in
step 8.
11
12
• Insert and tighten screw you removed in
step 7.
• Reconnect cables.
13
14
• Slide the protective case over the extruder.
• Insert and tighten the screw you removed
in step 4.
• Insert and tighten screw again you removed
in step 3.
15
• Reconnect the power cable.
• Switch the 3D printer on.
• Calibrate build bed as usual (for details
refer to RF100 operating instructions).
The extruder unit is equipped with a 0.4 nozzle mm. In “Cura“ software the “Nozzle
size“ in “Basic“ settings is set to “0.4 mm“ (default setting). Before printing, ensure
the correct “Nozzle size“ is set.
Disposal
Electronic devices are recyclable waste and must not be disposed of in the
household waste. At the end of its service life, dispose of the product according to
the relevant statutory regulations.
You thus full your statutory obligations and contribute to the protection of the environment.
Technical data
Dimensions (L x H x W) ................ 60 x 93 x 42 mm
Weight .......................................... approx. 352 g
Nozzle (ø) ..................................... 0.4 mm