Information

26
M3 x 12
mm
21
22
• Fasten the fan with the screws. There are no tapped
holes in the heat sink for these screw ttings. For
each screw there is a self-tapping thread between two
cooling ribs.
• Tighten the screws until they are at with the fan.
• Tighten the screws from step 20.
• Reconnect the plug.
23
M3 x 6
mm
24
• Take note of extruder position.
• Place the extruder on the extruder carriage. Align
extruder with tapped holes in the extruder carriage.
• Insert and tighten the screw to fasten the extruder at
the extruder carriage.
M3 x 5
mm
25
26
• Insert and tighten the screw to fasten the extruder at
the extruder carriage.
• Reconnect the plug.