Instructions

19
1
2
15
16
• Carefully slide the nozzle throat into the extruder as
far as it will go (
1
).
Make sure the side of the thermistor‘s protruding cable
s are facing to the front.
• Fasten the nozzle throat with the grub screw and
tighten it (
2
).
• Reconnect the plug.
The connector can only be connected in one direction.
17
18
• Secure the cables of the fan and the thermistor with
the cable tie (included in the delivery content).
• Use the side cutter to cut the cable binding end.
• Attach the bracket to the heatsink using the screw.
Tighten the screw.