Instructions

16
7. Replace thermistor with heater
Danger of burns! Do not touch the hot nozzle. Switch off the 3D printer and disconnect it from the power
supply. Let the 3D printer cool down to room temperature before you start with the replacement.
Required tools
1,5 mm hex key included in delivery content
2 / 2,5 mm hex key
supplied with item no. 1507428
side cutter
• Use a suitable hex key to remove or tighten the screws.
1
2
• Switch the 3D printer off.
• Remove the build bed carefully.
• Remove the power cable.
• Cut the existing lament in the extruder with the side
cutter.
3
4
• Remove the screw at the side of the protective case.
• Remove the screw on the front of the protective case.