User manual

28
10. Operation
a) Setting the operating mode
The effect light can be controlled with the integrated controller or with an external DMX controller. Ad-
ditionally, it can be used as a master device with integrated controller to control other connected effect
lights synchronously in master-slave operation, or as slave device via the controller of another DL-LED162
effect light.
Use the LED display and function buttons MODE, ENTER, UP and DOWN to set the operating mode.
• Push the button MODE to choose the setting mode.
• Push the button ENTER to choose the submenu.
The display automatically returns to the MODE setting after a few seconds.
• Select the desired setting/operating mode with the UP and DOWN buttons.
The DMX connection takes precedence. If an active connection to a DMX-controller has been
created, the buttons on the rear of the device can only be used to set the DMX address, the slave
settings and the DMX mode (Ch2 or Ch9).
The following table shows the effects of the settings.
MODE ENTER UP / DOWN
A001-A512 A001-A512 DMX address
2CH / 9CH DMX mode
SL 1 / SL 2 SL 1, slave function, effect analogue master
SL 2, slave function, effect reverse to master
So01-So30 So01-So30 Sound Control Programmes
AU01-AU30 AU01-AU30 Auto Programmes
SP01-SP99 Speed control for audio programmes
Led Led Display orientation is rotated
Leon-LeoF Leon = LED display steady light
LeoF = LED display switches off after approx. 20 sec. if a key is not
pressed any more. Press any key to activate the display.