User manual
27
e) Use with an External DMX Controller
Each DMX device in a DMX chain requires a so-called DMX starting address to be clearly identified by the
controller. This DMX starting address specifies the first DMX channel to which the eect light responds.
The remaining control channels come after this first DMX channel (DMX starting address).
The eect light requires 3 or 6 free DMX channels depending on DMX operating mode.
Setting the DMX operating mode
• Set >> 6 ch in menu ChNd to operate the device in 6-channel DMX operation.
• Set >> 3 ch in menu ChNd to operate the device in 3-channel DMX operation.
Setting the DMX starting address
• Push the button FUNC until Addr is displayed and push the button ENTER.
• Select the desired starting address 001-507 with the UP and DOWN buttons.
• Confirm your selection again with ENTER.
The following tables provide information about the eects of the settings on the individual DMX channels.
6-channel DMX operation
DMX channel Value Function
1 000 Light o
001-255 Overall brightness
2 000-015 Automatic operation o
016-255 Automatic operation slow > fast
3 000-127 Flashing eect o
128-255 Flash eect slow > fast
4 000-255 Brightness red
5 000-255 Brightness green
6 000-255 Brightness blue
3-channel DMX operation
DMX channel Value Function
1 000-255 Brightness red
2 000-255 Brightness green
3 000-255 Brightness blue