Information

ManualsBrandsRENKFORCE ManualsDoor & Window ProtectionCode lock type 12 Vdc IP65 + backlit keypad

Access mode

= Automatic access mode ("Auto-Entry")

= Manual access mode (the button must be pushed after code input)

Important!

For automatic access mode ("Auto-Entry"), all user codes must have the same

length (e.g. master code, superuser code, user codes, visitor code must have 5

digits each).

(Access mode) = Manual access mode

Switching the signal sounds of the code lock

on/off

= Signal sounds off

= Signal sounds on

(Signal sound function) = Signal sounds on

Signalling for valid user code or valid tran-

sponder

= No signalling

= Beep for 1 second

= Two brief beeps

(Signal sound function) = Beep for 1 second

Switching the ashing signal of the LED in

regular operation on/off

= Flashing signal off

= Flashing signal on

(Flashing signal function) = Flashing signal on

Operating mode for the door opener button

= Briey push door opener button, no sound signal

= Briey push door opener button, with sound signal

= Keep door opener button pushed, no sound signal

= Keep door opener button pushed, with sound signal

(Operating mode) = Briey push door opener button, no sound signal

Operating mode for code lock

= Standalone mode

= External device present

(Operating mode) = Standalone mode

Default master code and unchangeable system codes:

System codes Function Input form Result

Default setting of the master code at rst commissioning

(must be changed by you)

= Calling programming mode at rst commissioning

(Master code) = Calling the programming mode with your master code

If a new master code is programmed, it will overwrite the previous master code. The "old" master code will no

longer work then.

The code lock is in programming mode.

Deleting all codes and settings and reset to default settings (the master

code is not reset)

Start programming mode, then enter (the subsequent deletion may take 2 minutes).

All codes and transponders have been deleted; all settings are reset to factory settings. The master code

is retained, however, and is not reset.

DAP-code, access to programming mode (in connection with the door

opener button), if you have forgotten the master code

If you have forgotten the master code, disconnect the code lock from the power supply for 1 minute. Connect the

code lock to the power supply again. The code lock will emit signal sounds. Briey push the door opener button.

Now enter within one minute to call the programming mode.

The code lock is in programming mode.

Deleting the user codes for output #1 or output #2 or deleting the

visitor codes

= Deleting all user codes/transponders for output #1

= Deleting all user codes/transponders for output #2

= Deleting all visitor codes

The data for the corresponding group ( or or ) are deleted.

Exit programming mode

The code lock is in regular mode and is waiting for a user code, visitor code or transponder.

Prematurely ending activation delay After connecting the code lock to the power supply, the code lock will emit signal sounds for one minute (it is

waiting for actuation of the door opener button and input of the DAP code). You can cancel the activation delay

with .

The code lock is in regular mode and is waiting for a user code, visitor code or transponder.

This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).

All rights including translation reserved. Reproduction by any method, e.g. photocopy, microlming, or the capture in electronic data processing systems require the prior

written approval by the editor. Reprinting, also in part, is prohibited. This publication represent the technical status at the time of printing.