User manual
33
c) Manual Operation
In manual mode, the fog machine can be operated via the wired remote control, the IR remote control or
the button MANUAL SWITCH (6).
With DMX mode active, manual operation is not possible.
• Set the desired colour in the menu item CoLo (see menu overview).
• If required, activate the IR remote control in the menu item InFr (see menu overview).
• Press the red button on the wired remote control. The device emits fog as long as you keep this button
pressed.
• Align the IR remote control with the IR receiver (8) and press the button ON. The device produces fog
until you push the button OFF.
• Press the MANUAL SWITCH (6) button at the rear of the device. The device produces fog until you push
the button again.
d) DMX Mode
Each DMX device in a DMX chain requires a so-called DMX starting address to be clearly identified by the
controller. This DMX starting address specifies the first DMX channel to which the eect light responds.
The remaining control channels come after this first DMX channel (DMX starting address).
The eect light requires 7 DMX channels.
Setting the DMX starting address
Set the desired DMX start address in the menu item Addr (see menu overview).