Instructions

** Enter Setup
Exit Setup 10
Sense Mode
Sense Mode: The scanner activates a decode session every time when it detects a change in
ambient illumination and meets the requirement of the image stabilization timeout. Decode session
continues until barcode is decoded or the decode session timeout expires.
Sense Mode
Decode Session Timeout: This parameter sets the maximum time decode session continues during
a scan attempt. It is programmable in 1s increments from 1s to 255s. The default timeout is 15s. If the
parameter is set to 0, the decode session timeout is infinite.
Decode Session Timeout
Example: Set the decode session timeout to 5s
1. Scan the Enter Setup barcode.
2. Scan the Decode Session Timeout barcode.
3. Scan the numeric barcode “5”. (See the Digit Barcodes section in Appendix)
4. Scan the Save barcode. (See the Save/Cancel Barcodes section in Appendix)
5. Scan the Exit Setup barcode.