User manual

- 11 -
Hardware Installation
Storage Interface  Chipset:
8 x SATA 6Gb/s connectors
- Support for RAID 0, RAID 1, RAID 5, RAID 10, and JBOD
USB  Chipset:
- 4 USB 3.0/2.0 ports (2 ports on the back panel, 2 ports available through the
internal USB header)
- 8 USB 2.0/1.1 ports (4 ports on the back panel, 4 ports available through the
internal USB headers)
Internal
Connectors
 1 x 24-pin ATX main power connector
 1 x 8-pin ATX 12V power connector
 8 x SATA 6Gb/s connectors
 1 x APU fan header
 2 x system fan headers
 1 x front panel header
 1 x front panel audio header
 1 x S/PDIF Out header
 1 x USB 3.0/2.0 header
 2 x USB 2.0/1.1 headers
 1 x serial port header
 1 x parallel port header
 1 x Clear CMOS jumper
 1 x Trusted Platform Module (TPM) header
Back Panel
Connectors
 1 x PS/2 keyboard/mouse port
 1 x D-Sub port
 1 x DVI-D port
 1 x optical S/PDIF Out connector
 1 x HDMI port
 2 x USB 3.0/2.0 ports
 4 x USB 2.0/1.1 ports
 1 x RJ-45 port
 3 x audio jacks (Line In, Line Out, Mic In)
I/O Controller  iTE
®
I/O Controller Chip
Hardware
Monitor
 System voltage detection
 APU/System temperature detection
 APU/System fan speed detection
 APU overheating warning
 APU/System fan fail warning
 APU/System fan speed control
* Whether the fan speed control function is supported will depend on the
cooler you install.
BIOS  2 x 64 Mbit ash
 Use of licensed AMI EFI BIOS
 Support for DualBIOS
™
 PnP 1.0a, DMI 2.0, SM BIOS 2.6, ACPI 2.0a