User manual

60
11. Resetting to the factory settings
a) Outdoor sensor
Proceed as follows to reset the outdoor sensor to factory settings.
Push the recessed button “RESET” (E3), for approx. 5 seconds, e.g. with a ballpoint
pen. The button is located at the rear of the sensor, below the battery compartment
lid.
• The system is now reset to factory settings.
Alternatively, you can also simply remove the batteries. Wait for at least
10 seconds before re-inserting them.
b) Projection radio alarm clock
Proceed as follows to reset the projection radio alarm clock to factory settings.
Push the recessed button “RESET” (B5), e.g. with a ballpoint pen. The button is locat-
ed at the rear, below the battery compartment lid.
• Release the button again when the display goes out.
The alarm clock will emit a brief sound and the display will show all display segments.
• The system is now reset to factory settings.
Alternatively, you can also simply remove the batteries. After the display has
gone out, wait for approx. 5 seconds before re-inserting the batteries.
The alarm clock must not be connected to the plug-in mains adapter for this.