User manual

44
c) Projector function
• In battery operation without plug-in mains adapter, the projector will only be activat-
ed for a few seconds when you push the button “SNOOZE/LIGHT” (A2) briefly.
Using the power adapter allows having the projection permanently enabled.
• To enable permanent projection, slide the “PROJECTION ON” (B10) switch on the
back to the right into position “ON”
If permanent projection is deactivated, you can push the button “SNOOZE/LIGHT”
(A2) for approx. 4 seconds to activate projection for 30 minutes.
• To turn the projection by 180°, push the button B9 (also on the rear).
• Use the focus setting wheel (B12) to bring the projection into focus.
• Swivel the projector (A4) forward or back to present the projection in the desired
location.
• The projection will display the time and temperature.
d) Display lighting
• In battery operation without plug-in mains adapter, the display lighting (amber) will
only be activated for a few seconds when you push the button “SNOOZE/LIGHT” (A2)
briefly.
Using the power adapter allows having the display illumination permanently enabled.
• To enable permanent display illumination, slide the “LIGHT ON” (B2) switch on the
back under the battery compartment cover to the right into position “ON”.
• The brightness of the display lighting can be adjusted in 2 steps. Push the switch B1
to “L” for darker and to “H” for brighter.
• When the display lighting is deactivated, it can still be activated for 5 seconds with
the button “SNOOZE/LIGHT” (A2).