User manual

AMD Turbo Core Technology
This item appears only when
the processor you adopt supports this fea
ture. Usa this to select enable or disable
AMD Turbo Core Technology.
Configuration
options:
[Auto]
and [Disabled]. The default value is
[Auto].
AMD 10 C-State Suppoh
This allows you ta enable or
disable AMD 10 C-State
Support. The default
value 5 [Enabled].
Processor Maximum
Frequency
lt will display Processor Maximum
Frequency for reference.
North Bridge Maximum Frequency
lt will display North Bridge Maximum
Fraquency for reference.
Processor Maximum Voltage
lt will display Prncessor Maximum
Voltage for reference.
MultiplierNoltage Change
This item
is set to
[Auto] by default. fit is set to [Manual],
you may adjust
the value of Processor
Frequency and Processor Voltage. However, lt is
recommended to keep the default value for system
stability.
CPU Frequency Multiplier
For safety and system
stability, it is not recommended to adjust the value
of this item.
CPU Voltage
lt allows you to adjust the
value of CPU voltage. However for safety and
system stability, it is not
recommended to adjust the value of this item.
NB Frequency Multiplier
For safety and system
stability, lt is not recommended to adjust the value
of this item.
CPU NB Voltage
lt allows
you to adjust
the value of CPU NB voltage. However, for safety
and System stability, it is not
recommended to adjust the value of this item.
HT Bus Speed
This feature allows you selecting Hyper-Transport bus speed. Configura
tion
options: [Auto],
[200MHz] to [2400MHz].
HT Bus Width
This feature allows you selecting
Hyper-Transport bus width. Configuration
options: [Auto], [8 Bit] and [16 Bit].
DRAM
Timing Configuratlon
DRAM Frequency
lf [Auto] is selected, the molherboard will detect the memory
module(s)
inserted and assigns appropriate frequency automatically.
DRAM
Timing Control
Use this to select DRAM control. The default value is [Auto].
Power
Down Enable
Use this item to enable Dr disable DDR power down mode.
Bank Interleaving
lnterleaving allows memory accesses to be spread out over banks on the
same node,
or accross nodes, decreasing access contention.
Channel
Interleaving
lt allows you to enable Channel Memory Interleaving. Configuration
op
tions:
[Disabled] and [Auto]. The default value is [Auto].
Memory Controller Mode
lt allows you to adjust the memory controller
mode. Configuration options:
[Unganged] and [Ganged]. The default value is [Unganged].
DRAM Timing Control
Fj
.z‘
DRAM
SIot
Usa
this to select DRAM slot to view SPD data. The default value is
[DDR3_A1].
m
CD
0
6
ASRock 970 Pro3 R2.0 Motherboard
ASRock 970 ProS R2.0 Motherboard
7