Information

ManualsBrandsRENKFORCE ManualsDoor & Window ProtectionDigital code lock Surface-mount Set 12 V IP65 + backlit keypad

Door alarm

= Door alarm turned off

= Door alarm turned on

(Door alarm feature) = Door alarm turned off

Audible tone for valid user code (output is

activated)

= No audible tone

= Two short beeps

= One long beep

(desired option) = Beep for 1 second

Access mode

= Manual access mode (the button must be pressed after entering a code)

= Automatic access mode ("Auto-entry")

Important!

In automatic access mode ("Auto-entry"), all codes must be the same length (master code, superuser code,

user codes, visitor codes and duress codes).

(Access mode) = Manual access mode

Switches the keypad/error tones on/off in

standby mode

= Audible tones are switched off

= Audible tones are switched on

(desired option) = Audible tones are switched on

Switches the "MAINS" LED on/off in standby

mode

= Flashing LED off

= Flashing LED on

(desired option) = Flashing LED on

Settings for door opener button

= The door opener (output #1) is activated for the preset time when the door opener button is pressed.

= The door opener will be activated 5 seconds after the door opener button is pressed. The code lock

will beep during this period.

= The door opener will be activated 10 seconds after the door opener button is pressed. The code lock

will beep during this period.

= The door opener will be activated when the door opener button is held down for 5 seconds. The code

lock will beep during this period.

= The door opener will be activated when the door opener button is held down for 10 seconds. The

code lock will beep during this period.

(Operating mode) = Output #1 will be activated for the preset time when the

door opener button is pressed.

Conguring an open door warning tone

= No warning tone

.... = Warning tone is played after 1 - 999 second delay has elapsed

(Door open function) = Function disabled

Non-adjustable system codes:

System codes Function Input format Result

All codes and settings will be deleted and restored to the factory

defaults (except the master code), and multi-user mode will be enabled.

Enable programming mode and enter (it may take a while for the code lock to delete the settings).

All codes (except the master code) and settings will be deleted and restored to the factory defaults.

Enable single-user mode (you can only congure one user code for

each output, plus one visitor code and one duress code)

Enable programming mode and enter . This will delete the existing codes (e.g. user codes).

All codes (except the master code) and settings will be deleted and restored to the factory defaults.

This mode is only designed for very basic scenarios. All codes (e.g. master code and user codes) must

be 4 digits long.

Exit programming mode

The code lock switches to standby mode and waits for a valid code.

This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).

All rights including translation reserved. Reproduction by any method, e.g. photocopy, microlming, or the capture in electronic data processing

systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication represent the technical status at

the time of printing.