User manual
39
Connection of the Z motor
Connect the new, longer cable for the Z-motor from the inside at the
Z-motor. Attach the cable as shown in the gure with an adhesive
base and cable tie.
Thread the cable from the inside through the cable feedthrough above
the main PCB and connect it to the connection for the Z-motor.
Ensurecorrectpolarity!Thebrownpinofthecablemustbeon
top.
Observe the terminal plan at the end of this chapter for this.
AttachingthePCBholder
Attach the PCB holder again in the existing slot nut with a M5-cylin-
der-head screw.