User manual
28
f) Slave Mode
• Use the button FUNC to select the setting SLNd.
• Push the ENTER button. The display ashes.
• Select the setting SLAv with the UP and DOWN buttons.
• Conrm the setting with the button ENTER while the display is ashing.
If no master signal is pending at the DMX-input, the display will show Stby.
g) Use with an external DMX Controller
Each DMX device in a DMX chain requires a so-called DMX starting address to be clearly identied by the controller.
This DMX starting address species the rst DMX channel to which the effect light responds. The remaining control
channels come after this rst DMX channel (DMX starting address).
The effect light requires 2 DMX channels.
Setting the DMX starting address
• Use the button FUNC to select the setting Addr.
• Push the ENTER button. The display ashes.
• Select the desired start address (001-511) with the UP and DOWN buttons.
• Conrm the setting with the button ENTER while the display is ashing.
The following table provides information about the effects of the settings on the individual DMX channels.
DMX CH CH Value Function Note
CH1
0 Light off; device without function
1-255 Total brightness (dimmer)
CH2
0-10 Continuous light
CH2 only works in conjunction with CH111-127 Sound-to-light mode
128-255 Strobe from slow to fast