User manual

27
b) Activate strobe function
• Use the button FUNC to select the setting ShNd.
• Push the ENTER button.
• Select the setting SPee with the UP and DOWN buttons.
• Push the button ENTER. The display (oFF; SP1-SP8) ashes.
• Select the desired strobe speed SP1 -SP8 with the UP and DOWN buttons. The strobe function is oFF with this
setting.
• Conrm the setting with the button ENTER while the display is ashing.
c) Sound-to-Light mode
• Use the button FUNC to select the setting ShNd.
• Push the ENTER button.
• Select the setting SoUn with the UP and DOWN buttons.
• Push the button ENTER. The display SoUn ashes.
• Conrm the setting with the button ENTER while the display is ashing.
The effect light is now controlled via the installed microphone in time with the music.
d) Permanent Light Mode
• Use the button FUNC to select the setting ShNd.
• Push the ENTER button.
• Select the setting NASt with the UP and DOWN buttons.
• Push the button ENTER. The display NASt ashes.
• Conrm the setting with the button ENTER while the display is ashing.
The LEDs are permanently lit in this setting. If the strobe function has been activated additionally, the LEDs will ash
at the set speed.
e) Master Mode
• Set the desired operating mode (NASt, SoUn) at the master device in the ShNd menu.
• Then, use the button FUNC to select the setting SLNd.
• Push the ENTER button. The display ashes.
• Select the setting NASt with the UP and DOWN buttons.
• Conrm the setting with the button ENTER while the display is ashing.
The rst device in the chain is set as the master unit. All further devices to be operated in the master-slave
chain are set as slave devices.